ABB DressPack IRB 6620LX Product Manual page 73

Securing and connecting
The procedure below details each inspection to be carried out, not necessarily in
any particular order unless stated.
1
2
3
4
5
6
Product manual - DressPack/SpotPack IRB 6620LX
3HAC055327-001 Revision: A
Action
Make sure that all cable clamps securing
the process cable package and protect-
ive hose are tightened correctly.
Make sure all cable straps are tight
enough to prevent the cable package
from moving in any undesired way.
Note
The cable straps/ties should not be too
narrow. It may damage the
cables/hoses.
When securing cables and hoses with
cable ties: never overtighten the ties!
This may damage the equipment.
Make sure that the cable package have
been properly connected at the base as
well as at the tool on the robot turning
disk.
Make sure all connection points are well
tightened and sealed in order to avoid
leaks.
Make sure the weight of the cable pack-
age is secured to the tool in order to
avoid straining the connectors!
© Copyright 2016-2017 ABB. All rights reserved.
2 Installation
2.2.6 Inspection, DressPack upper arm
Note
Tightening torques are specified:
• For standard tightening torques - See
tightening torque table in chapter
References.
• For non standard tightening torques -
See Installation chapter.
Continued
73