Table of Contents
Advertisement
C
OMPLETING THE
Once the USB2connect is installed in your system, complete the
following steps.
Windows® Installation
Power up the computer. During the operating system startup, the
S
1
TEP
card will automatically be detected and Windows will load an
embedded driver for the card. If your system prompts you to
restart the computer, do so.
If the New Hardware Found Wizard opens when you restart,
S
2
TEP
review the User's Guide on your USB2connect CD for more
information.
Review the Windows Device Manager to verify that the adapter is
S
3
TEP
installed under the USB Host Controller section. See the User's
Guide on your CD for more information.
Macintosh® Installation
Power up the computer. Insert the USB2connect CD into your
S
1
TEP
Macintosh CD-ROM drive.
Double-click the Start Installation Here file on your Installation
S
2
TEP
CD.
Follow the instructions to install the latest Macintosh USB
S
3
TEP
drivers, if necessary.
Double-click the USB2connect Installer and follow the on-screen
S
4
TEP
instructions.
After the installation is complete, click Restart to reboot your
S
5
TEP
Macintosh, if necessary, and have the new settings take effect. See
the User's Guide on the CD for details.
I
NSTALLATION
4
Advertisement
Table of Contents
