Table of Contents
Advertisement
ARO-1130SA Installation and Hardware Guide
16
Exit from the Registry Editor and from Windows NT. Then
shut down the server.
17
Physically install the ARO-1130SA in the PCI/RAIDport
expansion slot.
18
Attach your boot drive to one of the SCSI channels controlled
by the ARO-1130SA and boot the server.
Scenario #2: Adding an AHA-294x, AHA-3940, or Other
AIC-78x0 Based Host Adapter to a RAID port I or II System
with an ARO-1130SA
These instructions assume that Windows NT is already installed on
the server and that the boot drive is connected to the SCSI channel
controlled by the ARO-1130SA. If the AHA-294x, AHA-3940, or any
other AIC-78x0 based host adapter is already installed, shut down
the server, remove the adapter from the slot, and restart the system.
Installing the AHA-2940, AHA-3940, or AIC-78x0 Family Driver
1
Start the Windows NT Control Panel and double click the
SCSI Adapters icon.
2
Click the Drivers tab and click Add.
3
Click Have Disk ..., and insert AIC-78xx Family Manager Set
diskette in the floppy disk drive. (This diskette was included
with your 2940 Family adapter.)
4
When the Install From Disk dialog box appears, type
a:\winnt\4_0 on the command line and click OK.
5
Select Adaptec AHA290x/291x/394x/494x/4944/AIC78xx PCI
SCSI Controller (NT 4.0) and click OK.
6
When a message appears asking if you want to restart
Windows NT, click No.
7
Exit from Control Panel.
B-6
Advertisement
Table of Contents
