Problems Running Snmp Agent On Your Windows Nt Server - Adaptec ARO-1130SA Installation And Hardware Manual

Raid option card for pc servers with raidport i or ii

Hide thumbs Also See for ARO-1130SA:

Table of Contents

ARO-1130SA Installation and Hardware Guide

–

The correct entries for HKEY_LOCAL_MACHINE\

SYSTEM\CurrentControlSet\Services\

CIOArrayManager RPC Event are:

DependOnService: REG_MULTI_SZ: CIOArrayManage-

ment CIOArrayManager RPC Command

DisplayName:REG_SZ: CIOArrayManager RPC Event

ErrorControl: REG_DWORD: 0x1

ImagePath: REG_EXPAND_SZ: Absolute Path of

"iomrpcev.exe"

ObjectName: REG_SZ : LocalSystem

Start: REG_DWORD : 0x02

Type: REG_DWORD : 0x10

Problems Running SNMP Agent on Your

Windows NT Server

If you have problems running SNMP agent, try the following:

Make sure you configure Windows NT base SNMP support,

including the appropriate trap community name and trap des-

tinations. The SNMP configuration is accessed via Control

Panel/Network/SNMP Service. If the SNMP service does not

appear as a configurable item, then SNMP support must be

installed from the Windows NT distribution media.

Verify that the values in the Registry match the values listed

below:

–

Make sure HKEY_LOCAL_MACHINE\SYSTEM\Current-

ControlSet\Services\SNMP\Parameter\ExtensionAgents

includes an entry like this:

3 REG_SZ SOFTWARE\Adaptec\CIOSNMP\

CurrentVersion

(where 3 should be replaced by the next unused number)

C-4

Table of Contents