Adaptec ARO-1130SA Installation And Hardware Manual page 40

ARO-1130SA Installation and Hardware Guide
Note:
To load the driver automatically at server bootup, make
sure the startup.ncf file includes the load command line for
the cda1000.dsk driver. (If you also have an Adaptec host
adapter that uses the Adaptec aic78xx.dsk driver, make sure
the driver loads after the cda1000.dsk driver.)
NetWare 3.12
Follow these instruction only if you are installing NetWare 3.12 for
the first time:
1
Follow the procedures in your NetWare documentation for
installing a new server. (For information on using a CD-ROM
drive on a NetWare server, see Appendix D, Using a CD-ROM
Drive.)
2
When you see the NetWare colon prompt (:), use the load com-
mand to install the driver from the appropriate Adaptec
Array1000xA Family Manager Set driver diskette (Disk A or
Disk B). (See Running the Array1000xA BIOS & Driver Selection
Utility on page 3-2 to determine the appropriate driver dis-
kette.)
The correct syntax to load the cda1000.dsk driver is
:load [ pathname ]cda1000
(For example, :load a:\netware\v3_1x\cda1000)
Note:
copy the aspitran.dsk and cda1000.dsk drivers to the
server's startup directory and modify the startup.ncf so
that the proper path to the driver is specified .
The aspitran.dsk driver must reside in the same path as
cda1000.dsk , because NetWare attempts to load this file
automatically. If you also have an Adaptec host adapter
that uses the Adaptec aic78xx.dsk driver, make sure the
driver loads after the cda1000.dsk driver.
6-4
To load the drivers automatically at server bootup,