Table of Contents
Advertisement
7
Select NetWare 4.0 TIRPC Runtime and Configuration Files.
(TIRPC must be installed in the sys:system directory only.)
Installing the Adaptec CI/O Management
Software for Novell NetWare
Note:
Before you start the Adaptec CI/O Management Soft-
ware, be sure that communication with the server via the
network is already established. (See the documentation pro-
vided with your TCP/IP software for instructions on estab-
lishing communications, and also Hints for Establishing
Communications With Your Server on page 7-3.)
Follow these steps to install the Adaptec CI/O Management Soft-
ware for Novell NetWare:
1
Insert the Adaptec CI/O Management Software CD-ROM in
your CD-ROM drive. If you are installing the software from
diskettes, insert Disk 2 of the Adaptec CI/O Management Soft-
ware for NetWare in the floppy disk drive.
2
From the NetWare colon prompt (:), type the following and
press Enter:
load [pathname] nwsetup
(The nwsetup NLM is located at \netware\disk2\nwsetup.nlm
on the CD-ROM, and at \nwsetup.nlm on Disk 2 of the Adaptec
CI/O Management Software for NetWare.)
Note:
Failed to allocate resources error message at this
point. This is because the CD-ROM (or floppy disk
drive) is not part of the default search path. If this hap-
pens, you must add the CD-ROM or floppy disk drive
to your search path by entering the following com-
mand before loading nwsetup:
Installing Software on a Novell NetWare Server
If you are using NetWare 3.12, you may receive a
search add [pathname]
6-7
Advertisement
Table of Contents
