Table of Contents
Advertisement
Note:
CD-ROM, make sure BIOS Support for Bootable
CD-ROM is enabled in SCSISelect.
2
Windows NT Boot diskette installation: When prompted, insert
diskette #2 in your floppy drive. After a few moments you will
see a blue screen. To setup Windows NT now, press Enter and
continue with Step 3 below.
Windows NT Boot CD-ROM installation: When the following
message appears onscreen, press the F6 key and skip to Step 4
below.
Setup is inspecting your computer system's hardware...
3
Press S to skip autodetection of your SCSI host adapter.
4
Press S again to specify an additional device.
5
Press Enter to select Others; insert the Appropriate Adaptec
Array1000xA Family Manager Set driver diskette (Disk A or
Disk B) in your floppy disk drive and press Enter. (See Run-
ning the Array1000xA BIOS & Driver Selection Utility on page
3-2 to determine the appropriate driver diskette.)
6
The screen displays the adapter drivers supported on the
diskette. Select the Adaptec Array1000xA Family Adapter
driver and press Enter.
7
If you want to add drivers (other than for the ARO-1130SA), do
press S and repeat Step 5 for each additional adapter and
inserting the appropriate disk provided by the hardware man-
ufacturer.
8
Press Enter to continue with the Windows NT operating
system setup. Follow the instructions onscreen and in the
Windows NT documentation to complete the installation.
Installing Software on a Windows NT Server
To install Windows NT from a bootable
5-3
Advertisement
Table of Contents
