Connecting The Led Cable To The Aro-1130Sa - Adaptec ARO-1130SA Installation And Hardware Manual

Connecting the LED Cable to the ARO-1130SA

(Optional feature) An LED on the front panel of most computers
lights to indicate non-SCSI hard disk activity. If you would like that
LED to light whenever there is activity on SCSI Channel A (con-
trolled by ARO-1130SA), disconnect the LED cable from the mother-
board and connect it to the LED connector on the ARO-1130SA. If
the LED has a two-position cable, connect the cable to pins 1 and 2 of
the LED connector, as shown in Figure 2-4.
If the ARO-1130SA supports multiple SCSI channels, and you want
the LED to light whenever there is activity on any of those channels,
refer to your motherboard documentation for instructions on setting
the appropriate motherboard jumpers.
Note:
If you are using non-SCSI disk drives (e.g., IDE), the
LED may no longer indicate activity on these drives when
you connect the LED cable to the ARO-1130SA.
1
2-pin LED Cable
Figure 2-4. Connecting the LED Activity Indicator Cable
Installing ARO-1130SA Hardware
LED Cable
1
LED Connector on
ARO-1130SA
2-5