Exiting Scsiselect; Using Scsiselect Settings; Basic Host Adapter Settings - Adaptec 2940U2W User Manual

Note:
If you have difficulty viewing the display, press F5 to
toggle between color and monochrome modes. (This feature
may not work on all monitors.)
Exiting SCSI Select
Follow these steps to exit SCSISelect:
1
Press Esc until a message prompts you to exit (if you changed
any settings, you are prompted to save the changes before you
exit).
2
At the prompt, select Yes to exit, then press any key to reboot
the computer. Any changes you made in SCSISelect take effect
after the computer boots.
Using SCSI Select Settings
To select an option, use the
option, then press Enter.
In some cases, selecting an option displays another menu. You can
return to the previous menu at any time by pressing Esc.
To restore the original SCSISelect default values, press F6 from the
main SCSISelect screen.

Basic Host Adapter Settings

Host Adapter SCSI ID—Sets the SCSI ID for the SCSI card.
The SCSI Card 2940U2W is set at 7, which gives it the highest
priority on the SCSI bus. We recommend you do not change
this setting.
SCSI Parity Checking—When set to Enable, verifies the accu-
racy of data transfer on the SCSI bus. Leave this setting
enabled unless any SCSI peripheral connected to the SCSI Card
2940U2W does not support SCSI parity.
Configuring the SCSI Card 2940U2W with SCSISelect
and keys to move the cursor to the
17