Basic Host Adapter Settings - Adaptec SBC-596 Owner's Manual

Host Adapter SCSI ID
SCSI Parity Checking
Host Adapter SCSI Termination
Boot Target ID
Boot LUN Number
Initiate Sync Negotiation
Maximum Sync Transfer Rate
Enable Disconnection
Initiate Wide Negotiation
Send Start Unit Command
Plug and Play SCAM Support
Host Adapter BIOS
Support Removable Disks Under BIOS as Fixed Disks
Extended BIOS Translation for DOS Drives >1 GByte
Display <Ctrl-A> Message During BIOS Initialization
Multiple LUN Support
Support for Ultra SCSI Speed
1. Setting is valid only if multiple LUN Support is enabled.
2. Settings are valid only if host adapter BIOS is enabled.
The basic host adapter settings are the SCSISelect settings most
likely to require any modification.
Host Adapter SCSI ID - This option sets the host adapter's
SCSI ID. The default setting is SCSI ID 7, which give the
1
Chapter 6 SCSI Setup and Configurations
7
Enabled
Low ON/High ON
0
0
Yes (Enabled)
Yes (Enabled)
20 MBytes/sec
Yes (Enabled)
No (Disabled)
Disabled
Enabled
2
Boot only
2
Enabled
2 Enabled
Disabled
Disabled
71