Table of Contents
Advertisement
ARO-1130SA Installation and Hardware Guide
Using Driver Disk B
If the Array1000xA BIOS & Driver Selection Utility determines you
require Disk A of the manager set driver diskettes, the rest of this
appendix does not apply. If Disk B is required, then note the follow-
ing for these Adaptec products:
AHA-294x, AHA-3940, or any other AIC-78x0 based host
adapter: These host adapters can coexist with an ARO-1130SA
inside a RAIDport I or II system using Windows NT or
NetWare. In Windows NT, however, it is necessary to make
some modification to your Windows NT configuration. See
Using the ARO-1130SA with an AHA-294x, AHA-3940, or Other
AIC-78x0 Based Host Adapter and Driver Disk B (Windows NT
Only) below.
AHA-3940AU/3940AUW: Due to a PCI ID conflict with the
hardware on the motherboard that requires driver Disk B,
these host adapters cannot coexist with an ARO-1130SA inside
a RAIDport I or II system.
Using the ARO-1130SA with an AHA-294x,
AHA-3940, or Other AIC-78x0 Based Host
Adapter and Driver Disk B (Windows NT Only)
This section offers two scenarios for using the ARO-1130SA in a sys-
tem also containing any of the above host adapters. If the
Array1000xA BIOS & Driver Selection Utility (see Chapter 3) deter-
mines you require Disk B of the manager set driver diskettes, follow
the scenario below that matches your situation. You will need to
install drivers and make changes to the Windows NT Registry.
If the Array1000xA BIOS & Driver Selection Utility determines you
require Disk A, this section does not apply. To install the driver, fol-
low the instructions in Installing the Array1000xA Driver for Windows
NT on page 5-2.
Caution:
the Windows NT Registry unless you are an experienced
computer user.
B-2
We recommend that you do not attempt to change
Advertisement
Table of Contents
