Installing The Driver When Netware Is Already Installed - Adaptec ARO-1130SA Installation And Hardware Manual

Raid option card for pc servers with raidport i or ii

Hide thumbs Also See for ARO-1130SA:

Table of Contents

Load the NetWare install program from the NetWare colon

prompt (:load install). Follow the instructions in the NetWare

documentation to complete the installation (e.g., creating disk

partitions, system volumes, etc.) of your server.

Installing the Driver When NetWare is Already Installed

To update or install the cda1000.dsk driver if NetWare is already

installed, follow the instructions in this section. The procedures are

similar for all versions of NetWare. Procedures that are specific to a

NetWare version are noted when necessary.

Copy the cda1000.dsk and aspitran.dsk files from the appro-

priate Adaptec Array1000SA Family Manager Set driver dis-

kette (Disk A or Disk B) into the server's startup directory (e.g.,

c:\nwserver, c:\server.312 ) on your hard disk drive. (See Run-

ning the Array1000xA BIOS & Driver Selection Utility on page

3-2 to determine the appropriate driver diskette.)

Note:

aspitran.dsk files are located in the \netware\v3_1x

subdirectory on the diskette; for NetWare 4.11, the files

are in \netware\v4_xx .

If necessary, modify the load command line in the startup.ncf

so that the proper path to the driver is specified. The correct

syntax to load the cda1000.dsk driver is

load [ pathname ]cda1000

Note:

If you unload cda1000.dsk driver, you must also

unload cioams.nlm . When you load cda1000.dsk driver

again, you must also load cioams.nlm . If cioams.nlm is not

unloaded when you unload cda1000.dsk , your system may

work erratically.

Installing Software on a Novell NetWare Server

For NetWare 3.12, the cda1000.dsk and

6-5

Table of Contents