Installing Software On A Novell Netware Server - Adaptec ARO-1130SA Installation And Hardware Manual

Installing Software on a
Novell NetWare Server
This chapter explains how to install the software required to use the
ARO-1130SA in a Novell NetWare (NetWare 3.12 and 4.11) server.
Before installing the software, make sure the ARO-1130SA is already
installed. If you have not already done so, run the Array1000xA BIOS
& Driver Selection Utility (see Chapter 3) to determine which of the
two Manager Set driver diskettes (Disk A or Disk B) is required to
install the NetWare driver.If you plan to boot from an array, make
sure the array is already created. To install all of the software, you
must complete the following in the order presented:
Install the cda1000.dsk driver for Novell NetWare
Install the TIRPC Communications Module
Install the Adaptec CI/O Management Software for Novell
NetWare
Once all software is installed, refer to the Adaptec CI/O Management
Software User's Guide for instructions on adding, deleting, and man-
aging your arrays from the server console.
Note:
If your RAIDport I or II system has an additional
Adaptec AHA-2940, AHA-3940, or any other AIC-78x0
based host adapter installed, the NetWare driver for these
adapters must be from the Adaptec 7800 Family Manager
Set 1.3 or later. Furthermore, if the Array1000xA BIOS &
Driver Selection Utility determines you require Disk B, refer
to Appendix B.
6
6-1