Table of Contents
Advertisement
Installing Software on a
Windows NT Server
This chapter explains how to install the software required to use the
ARO-1130SA in a system using Windows NT 4.0 Server.
Before installing the software, make sure the ARO-1130SA is already
installed. If you have not already done so, run the Array1000xA
BIOS & Driver Selection Utility (see Chapter 3) to determine which
of the two Manager Set driver diskettes (Disk A or Disk B) is
required to install the Window NT driver. If you plan to boot from
an array, make sure the array is already created. To install all of the
software, you must complete the following in the order presented:
Install the cda1000.sys driver for Windows NT
Install the Adaptec CI/O Management Software for Windows
NT
Once all software is installed, refer to the Adaptec CI/O Management
Software User's Guide for instructions on adding, deleting, and man-
aging your arrays.
Note:
If your RAIDport I or II system has an additional
Adaptec AHA
based host adapter installed (which is not associated with
the RAIDport), the driver for these adapters must be from
the Adaptec 7800 Family Manager Set 1.3 or later. Further-
more, if the Array1000xA BIOS & Driver Selection Utility
determines you require Disk B, refer to Appendix B.
®
-2940, AHA-3940, or any other AIC
5
™
-78x0
5-1
Advertisement
Table of Contents
