8. Using a 3/16 nut driver, remove the two nuts on either side of the AES3 output. Set the nuts
aside.
9. Using a 2.5 mm ball hex driver, remove the left screw securing the Christie IMB to the
faceplate. Set the screw aside.
10. Rotate the assembly 180 degrees.
11. Using a 2.5 mm ball hex driver, remove the right screw securing the Christie IMB to the
faceplate. Set the screw aside.
Retrofitting the Solaria One with the GDC SR-1000 IMB Instruction Sheet
020-102945-03 Rev. 1 (05-2019)
Copyright
2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Retrofitting the Solaria One with the GDC SR-1000 IMB
5