Turning Off The Projector - Christie Solaria One Instruction Sheet

7. To upgrade all components in the upgrade package, select Upgrade Different Components
Only (Recommended).
8. Tap Next.

Turning off the projector

Before removing the card cage, turn off the projector and disconnect it from AC power.
1. To turn off the lamp, tap and hold the lamp button on the touch panel controller (TPC).
2. To turn off the projector, tap and hold the power button on the TPC.
The projector enters cool down mode.
3. Allow the lamp to cool for a minimum of 10 minutes.
4. Unplug the AC power cable from the projector.
Disassembling the card cage faceplate and
board assembly
Complete the following procedure to remove the faceplate and board assembly from the projector and
take apart the components.
1. Place the electrostatic discharge mat on a clean flat surface.
2. Put on the grounded electrostatic discharge wrist strap.
3. Cut the void warranty label.
4. Using a #2 Phillips
the card cage. Set the screws aside.
Retrofitting the Solaria One with the GDC SR-1000 IMB Instruction Sheet
020-102945-03 Rev. 1 (05-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Retrofitting the Solaria One with the GDC SR-1000 IMB
®
screwdriver, remove the eight screws securing the card cage faceplate to
3