Required Tools; Safety Precautions - Christie DHD630-GS Installation Manual

Lens sift 2 components
Quantity
1
3
1

Required tools

The following tools are required.
• Long neck #2 Phillips screwdriver
• L-shaped socket key provided with the lens kit
• 2.5 mm allen key
• 5 mm hex nut driver
• 10 mm hex key wrench

Safety precautions

When installing the ultra short throw lens, observe these important safety rules to avoid personal
injury or damage to the projector.
Warning! If not avoided, the following could result in death or serious injury.
• Do not look directly into the lens when the light source is on. The extremely high brightness can
cause permanent eye damage.
• EXTREME BRIGHTNESS! Make sure no personnel or objects are in the product light path.
Caution! If not avoided, the following could result in minor or moderate injury.
• All procedures must be performed by Christie qualified technicians.
• SHOCK HAZARD! Always turn off power when replacing product components.
• TIP HAZARD! Place the product on a stable surface.
Completing the ultra short throw lens installation
setup
To complete the installation setup, enter UST mode and start a lens calibration.
1. If you have a non-ultra short throw lens, complete the following steps:
a) Install a non-ultra short throw lens in the projector.
b) Power on the projector.
c) Access the Service menu.
Ultra Short Throw Lens Installation Instruction Sheet
020-102569-07 Rev. 1 (12-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Ultra short throw lens installation
Description
Ultra short throw lens pogo adapter
Boresight extension rods (with red rubber ring)
Boresight L-shaped socket key (black)
or
Boresight U-shaped socket key (black)
3