Christie Solaria One Instruction Sheet page 6

12. Using a 2.5 mm hex driver, remove the two screws on the bottom of the PIBS1 board. Set the
screws and support bracket aside.
13. Carefully separate the Christie IMB from the faceplate. Set the Christie IMB aside.
14. Using a 3/16 nut driver, remove the 3D Sync, RS 232 PIBS1, HDMI A/LEFT, and HDMI B/RIGHT
nuts. Set the nuts aside.
Retrofitting the Solaria One with the GDC SR-1000 IMB Instruction Sheet
020-102945-03 Rev. 1 (05-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Retrofitting the Solaria One with the GDC SR-1000 IMB
6