A.8. Jumper Setting; Io1 Jumper Settings For Different Module Positions; Cascading Of Io1 (Or Other) Modules Onto The Cp321 - Kontron PEP CP321 Manual

CP320-IO1 Module

A.8. Jumper Setting

The jumper settings of the IO1 module depend on the module's position relative to the CP321
and other modules, if any (please see Figure A4 below).
Table A-5: IO1 Jumper Settings for Different Module Positions
IDSEL
POSITION
J12 J11
P1 Set Open
P2 Open Set
Note...
Position P1 refers to the settings applicable for a module attatched to
the CP321 in position P1.
Position P2 refers to the settings applicable for a module attatched to
the CP321 in position P2.
Figure A-5: Cascading of IO1 (or other) Modules onto the CP321
U W H
RS T AB
LNK.
ACT. SPEE D
P1
Page A - 14
CLOCK
J10 J1 J2
Open Set Open
Open Open Set
P2
© 2003 Kontron Modular Computers GmbH
GNT#
J3 J4 J5 J6
Open Set Open Open
Open Open Set Open
KEY
P1: 1 additional module
P2: 2 additional modules
CP321
REQ#
J7 J8 J9
Set Open Open
Open Set Open
ID 24977, Rev. 02