Kontron PEP CP321 Manual page 102

NetBootLoader
LS
FUNCTION:
SYNTAX:
DESCRIPTION:
MD
FUNCTION:
SYNTAX:
DESCRIPTION:
Page 5 - 22
Display listing of the current ftp server directory
ls
To display a listing of the current ftp server directory the command
"ls" is used. This command downloads the listing to the data buffer
and then the listing is displayed. Any previously loaded image in the
data buffer is overwritten. If an attempt is then made to program the
FLASH after the "ls" command has been issued it will fail.
Display visible memory
md [<adr>]
where:
md command
<adr> parameter: value: hexadecimal
starting address of a visible memory area
To display a visible memory area the command "md" is used. The
first time the command "md" is issued, visible memory contents
starting at the address 0x0 are displayed if no "<adr>" parameter is
used. If issued again without the "<adr>" parameter, the display starts
with the end address of the previous display. Data is displayed as
hexadecimal 32-bit words and as ASCII dump.
© 2003 Kontron Modular Computers GmbH
CP321
ID 24977, Rev. 02