Kontron PEP CP321 Manual page 94

NetBootLoader
BW
DESCRIPTION:
USAGE:
BYE
FUNCTION:
SYNTAX:
DESCRIPTION:
Page 5 - 14
The command "bw" displays the parameter "<time>" setting.
The parameter "<time>" stipulates the waiting time in seconds that
the boot operation is delayed before the application is loaded and
started. No values other than these are supported.
Bear in mind when setting the boot wait time that the MC6 (LED1)
signal is asserted alternately at the rate of two times a second.
Therefore, if the boot wait is set to 1 second the MC6 signal will only
be alternately asserted two times.
The option "-f" is used to force updating of the CRC value of boot
section of the EEPROM.
For further information refer to chapter 5.4.3.1.
Display setting of "<time>" parameter
COMMAND / RESPONSE:
bw
WaitTime: 20
Set boot wait time to 50 seconds
COMMAND / RESPONSE (none):
bw 50
Terminate an ftp server session
bye
An ftp server session which has been established with the command
"login" is terminated with the command "bye".
© 2003 Kontron Modular Computers GmbH
CP321
ID 24977, Rev. 02