Set Communication - ADF Web HD67618-A1 User Manual

Industrial Electronic Devices

SET COMMUNICATION:

This section define the fundamental communication parameters of two buses, Modbus TCP
and S7comm.
By Pressing the "Set Communication" button from the main window for SW67618 (Fig. 2)
the window "Set Communication" appears (Fig. 3).
The means of the fields for "S7 Protocol" are:
In the fields "IP ADDRESS" the IP address for S7comm side of the converter is
defined;
In the fields "SUBNET
defined;
In the fields "GATEWAY" the default gateway of the net is defined. This feature can
be enabled or disabled pressing the Check Box field. This feature is used for going
out of the net;
In the field "Port" the port used for Modbus TCP communication is defined.
The means of the fields for "Modbus TCP Slave" are:
In the fields "IP ADDRESS" the IP address for Modbus TCP side of the converter is
defined;
In the fields "SUBNET
converter is defined;
In the fields "GATEWAY" the default gateway of the net is defined. This feature can
be enabled or disabled pressing the Check Box field. This feature is used for going
out of the net;
In the field "Port" the port used for Modbus TCP communication is defined.
ADFweb.com Srl – IT31010 – Mareno – Treviso
Mask" the SubNet Mask for S7comm side of the converter is
Mask" the SubNet Mask for Modbus TCP side of the
User Manual S7comm / Modbus TCP Slave
Document code: MN67618_ENG Revision 1.000
Figure 3: "Set Communication" window
INFO: www.adfweb.com
Page 15 of 25
Phone +39.0438.30.91.31