Figure 31. Keil ® Hotplug Step3 - STMicroelectronics STM32 Application Note

AN4989 Connecting to the board
®
Figure 31. Keil hotplug step3
With these options disabled, the debugger starts, and the target hardware stops at the
current location of the program counter. This allows to analyze the memory and register
content.
Because Options For Target - Debug - Load Application at startup is disabled, the debugger
does not have any application program and debug information. To load this information into
the debugger, use the LOAD debugger command with the option NORESET or
INCREMENTAL.
LOAD can be automated using an Initialization File under Options For Target - Debug.
To go further, refer to http://www.keil.com/.
AN4989 Rev 3 47/118
117