Figure 77. Access To Generator Options In Stm32Cubeide V2.0.0 - STMicroelectronics STM32 Application Note

Managing DBGMCU registers
STM32CubeIDE
By default, STM32CubeIDEenable Low-Power debug. This default setting can be changed
through Run->Debug Configurations->Debugger Pane.
•
Setting up with OpenOCD server
By clicking on the Show generator options as presented in the figure below.

Figure 77. Access to Generator Options in STM32CubeIDE V2.0.0

DBGMCU options are available under Reset Mode in the Mode Setup group as shown in
Figure 78.
102/118 AN4989 Rev 3
AN4989