Figure 89. Keil ® St-Link Selection - STMicroelectronics STM32 Application Note

Managing various targets on the same PC
®
Keil MDK-Arm µVision
The list of connected targets is visible in ST-LINK debug pane (Options -> Debug -> ST-
LINK -> Settings -> Debug Pane) as presented in
In the Debug Adapter section, the pick list allows to select among all connected targets.
At selection it can be observed a brief activity of the ST-LINK LED of the related board and
the Serial Number is displayed.
The selection is stored for the next connections.
STM32CubeIDE
If you try to launch a debug session with two ST-LINK connected, a pop-up message appear
as shown in the figure below:
112/118
®
Figure 89. Keil ST-LINK selection
AN4989 Rev 3
Figure 89.
AN4989