Figure 87. Iar™ Ewarm Debug Probe Selection With Nickname; Figure 88. Probe Selection Prompt Setting On Iar™ Ewarm - STMicroelectronics STM32 Application Note

AN4989 Managing various targets on the same PC
Figure 87. IAR™ EWARM Debug Probe Selection with nickname
Important: The pop-up window is displayed only at first time. The selection made is then
applied by default to further connections. Changing this initial selection requires that the
"Debug Probe Selection" display is forced by setting the "Always prompt for probe selection"
option in Option -> ST-LINK -> Setup as shown in Figure 88.
Figure 88. Probe selection prompt setting on IAR™ EWARM
AN4989 Rev 3 111/118
117