Figure 85. Getting Target St-Link S/N From The Console; Figure 86. Iar™ Ewarm Debug Probe Selection Pop-Up Window - STMicroelectronics STM32 Application Note

Managing various targets on the same PC
The next sections detail the selection of a specific target with each of the main IDEs
considered in this application note.
IAR™ EWARM
The first time a debug session is launched while several targets are connected, a Debug
Probe Selection window pops up.
A list of connected targets is displayed, identified by the last four bytes of the ST-LINK S/N
as illustrated in
It is recommended to use the Edit Nickname feature to ease board identification in
anticipation of further connection as shown in
110/118

Figure 85. Getting target ST-LINK S/N from the console

Figure 86.
Figure 86. IAR™ EWARM Debug Probe Selection pop-up window
Figure 87.
AN4989 Rev 3
AN4989