Explanation Of The Terms Used - Weber Geset 121 User Manual

Chapter 1 General information

Explanation of the terms used

Term
3-roll system
Adhesive strings
Air assist tube
Air assist
Air Blast)
Application cycle
Application mode
Applicator
Automatic mode
Blow-on
Chain orientation
Change separation device
Contrast
Conveying system
Conveyor
CS
Cycle
Cylinder
Sensor
Dancer arm
Version: 02.08.12
Explanation
Is used for labeling around of round products.
Glue that has leaked out at the edge of the label can hold the
label to the backing paper. The printed label remains stuck to
the backing paper and cannot be moved to the tamp pad.
The air assist tube conducts the supporting air through one or
more holes to the bottom of the label. It is attached next to
the peeler bar and can be adjusted.
A jet of air that, when the label is being fed, presses the label
against the bottom of the tamp until it is held by the vacuum.
Air that blows on the label through holes in the tamp pad at
the time of labeling (through house nozzles when there is a
blow box) so that the label is placed on the product without
being touched.
Complete operating sequence of the labeling system (such
as printing the label, peeling it off, transferring it to the
applicator and labeling the product).
See explanations: Tamp on, tamp blow, blow on and wipe on.
This identifies the label dispenser and mimic that moves the
tamp.
See labeling operation
Contact-less application mode in which the tamp receives the
printed label by a vacuum and blows it on to the product
without the tamp moving.
The chain orientation aligns rectangular and oval products
parallel and centered at the transport belt.
To label the fed products, they have to be fed separately to
the labeling system. The separation device separates the
products.
Difference in brightness of light and dark sections of a picture
/ print.
The unit consisting of the conveyor belt and its control
Belt for conveying the product
Abbreviation for conveying system (see above)
Steps of labeling from the detection of product, to the labeling
of the product, to the return to the initial position of the tamp.
Home-Position Sensor to detect home position if the cylinder is retracted.
The arm that holds the label liner taught by spring tension.
Page 9 of 71
32708732 Geset 121