Table of Contents
Advertisement
Chapter 2 Safety regulations
*²
Safety switch
*² Only if system has the appropriate features.
Workplaces for the operating personnel
The labeling station is an automated system and does not require operation while labeling.
When the labeling system is operating without any malfunction, the operator may
only be in the safe area, that is, the area covered by the protective measures.
Only one person is permitted to replace the labels and colored ribbon when the related
system has stopped and when the conveying system has stopped.
The access side is always the side where the operator panel is mounted. For servicing,
repairing and troubleshooting (remove the label from the applicator), etc., the labeling
system can be operated from all sides.
After troubleshooting and/or restarting the labeling station, the operator must
immediately leave the hazardous area and to stay in the area designated by the
safety measures.
Waste disposal
This label is in compliance with
observance of the prohibitions on use are and avoidance of pollutants.
*² Only if system has the appropriate features.
Version: 02.08.12
Safety switchs are mounted at the protective cabinets and
protective doors that can be opened. It is used to stop
immediately the system if the protective covers or doors have
been opened unintentionally. Turning on the system when the
protective cover or the protective door is still open, is not
possible.
Page 25 of 71
RoHS EU Directive 2002/95/AC given
32708732 Geset 121
Advertisement
Table of Contents
