Adjustment And Initial Operation - Weber Geset 121 User Manual

Chapter 7 Adjustment and initial operation of labeling system

Adjustment and initial operation

The labeling system has to be re-adjusted at initial operation or at a product change. In
following adjustment table all required working steps are listed.
Use the adjustment table as checklist and perform the necessary works for each purpose
in mentioned order. The works that are in need of an explanation are described in this
chapter.
Requirements
 Control about product transport.
 One or more sample products.
 Labeling system is connected to power.
 Triggering of labeling is possible by product sensor or I/O-interface.
Instruction
Please put the labeling system into operation as follows.
Further information about the single steps are mentioned on following pages.
Step Procedure
1 Fehler! Verweisquelle konnte nicht gefunden werden.
2 Change peeler blade
3 Pitch peeler blade (Gimbal adjustment)
4 Insert label roll in labeler
5 Insert label liner in labeler
6 Move label position in transport direction forward or backward
7 Correct adjustments after labeling result
*² Only if system has the appropriate features.
Version: 02.08.12
Page 39 of 71
32708732 Geset 121
Page
40
41
42
44
44
47
48