Change Peeler Blade - Weber Geset 121 User Manual

Chapter 7 Adjustment and initial operation of labeling system

Change peeler blade

Pos.
1
2
The peeler blade depend on product and label width. That is the reason why the
appropriate peeler blade has to be changed according to product and label. During
assembling, please consider that the bevel of the peeler blade shows in direction of the
product. The peeler blade has to be aligned in a distance of appr. 1 - 3 mm to the product.
Requirements
 Power and compressed air supply is turned off.
 No transportation of products.
Instruction
Please change the peeler blade as follows.
Step Procedure
1 Loosen the screws to the peeler blade's bracket and remove the peeler
blade.
2 Tighten the appropriate peeler blade with the screws at the peeler blade's
bracket. Observe that the bevel of the peeler blade shows in direction of
the product.
Version: 02.08.12
Fig. 7-2: Change peeler blade
Description
SCREWS FOR PEELER BLADE'S BRACKET
PEELER BLADE
Page 41 of 71
32708732 Geset 121