Table of Contents
Advertisement
Chapter 1 General information
Explanations of the terms used
Term
Application cycle
Application mode
Approval drawing
Automatic mode
Base conveyor
Blow-On
Conveying system
CS
Dancer arm
Default
Default
Gauge
Gimbal adjustment
HMI
Hotline
HPU
Infeed
Label feed
Version: 12.05.14
Explanation
Complete operating sequence of the labeling system (such
as printing the label, peeling it off, transferring it to the
applicator and labeling the product).
Depending on labeler's equipment, different application
modes can be applied. See explanations: Tamp on, tamp
blow, blow on and wipe on.
Customization of a series system is approved by the
customer via a drawing of Bluhm-Weber Group. This
approval drawing also includes individual performance data
of the machine.
See labeling operation
See
also
"conveying
transports the products that should be labeled.
Contact-less application mode in which the tamp receives
the printed label by a vacuum and blows it onto the product
without the tamp moving.
The unit consisting of the conveyor belt and its control.
Abbreviation for conveying system (see above)
The arm that holds the label liner taught by spring tension.
All basis settings for the system after it is made that can
differ from the status after the system is started up. The
software parameters can be returned to the defaults by
being reset, and any changed values are lost.
See factory-setting.
See "Service unit", Is used to display compressed air
The gimbal adjustment is used to align the longitudinal and
lateral inclination of the labeling system and thus the peeler
bar to product. The peeler plate has to be aligned parallel to
product.
Abbreviation for Human-Machine-Interface, input unit for a
labeling system or a controller of components.
Customer support for a fast diagnosis by phone.
The abbreviation of Height Processing Unit: A device that is
driven by a motor or pneumatically to move a labeler
vertically. This feature enables different labeling positions in
vertical direction.
The products are fed manually or by a conveying system
provided by the customer at infeed passage of the labeling
station.
Feeding of a label by the labeler. The fed label is printed on
within the print engine and peeled off at the peeler bar.
Page 8 of 56
40001684 BTA Geset 111
system".
The
base
conveyor
GB
Advertisement
Table of Contents
