Table of Contents
Advertisement
Chapter 9 Maintenance
Inspection
Errors and wear can early be perceived and remedied by the inspection before it leads to
damages.
Requirements
The labeling station is without power (no electrical power or compressed air)
The product is not being transported
Instruction
Please arrange the inspection as follows.
Step
1
2
3
4
5
6
7
8
9
10
11
12
13
14
*² Only if system has the appropriate features.
Version: 02.08.12
Procedure
Check the roll-and revolving bearing for free run.
Control the rolls for measure and rotation accuracy.
Control the pusher brushs, pusher rollers and peeler blade for wear.
Contol the guiding rails for wear.
Check all moving and rotating machine parts for free room of motion,
clearance and fixed hub.
Check all lines, tubes, screw connections, valves, cylinders and motors for
impermeability and fixed hub.
*² Check chains for correct tension, wear and elongation.
Check the tooth-and transport belts for correct tension and wear (fractures
and lacerated edges).
Check the transport belts for correct tape run.
Check all drive gears for correct meshing (wear, contamination).
Clean all sensors.
*² Check all working pressures and correct them if applicable.
Check motors and drives for noise, vibrations and overheating.
Check the emergency-stop device for function.
Page 60 of 71
32708732 Geset 121
Advertisement
Table of Contents
