Table of Contents
Advertisement
Chapter 8 Operation
Acknowledge errors
After a failure (e. g. roll end at labeling system), the error has to be acknowledged for a
new startup of the labeling system.
Requirements
Labeling system is turned on.
Material rolls at labeling system loaded and threaded.
Labeling system is connected to power and *² compressed air.
System was put into operation (see chapter „Adjustment and initial operation of
labeling system").
Instruction
Please acknowledge the errors at the labeling station as follows. .
Step
1
2
Version: 02.08.12
Procedure
Remedy the error's cause.
Hazard from actively controlled movements!
A labeling cycle is triggered by pushing the [Start] – button.
̶
Maintain a distance from moving parts.
Push the [START] –key at the labeler.
Page 55 of 71
32708732 Geset 121
Advertisement
Table of Contents
