Chapter 8 Operation
Turning off the system
Turning off the system is used to terminate production operation.
The label material running around the deflection rollers is curved which can cause prob-
lems with the operation mode. This characteristic of the labels as well as the retained cur-
vature depend on the material which can vary significantly between the different print me-
dia. The ambient conditions such as high temperatures and humidity enhance this effect
Requirements
Instruction
Please turn off the labeling system as follows.
Step
Procedure
1
If possible, run the system empty.
2
Stop the labeling station with the button [SYSTEM OFF].
3
Stop the labeler with the [STOP] – button.
4
Turn off main switch.
5
Remove products and put them away.
6
Remove label material and roll from labeling system and put them away.
7
Clean system and labeling system.
Version: 02.08.12
When turning off the system for several hours, the label web
must be removed from the applicator.
Labeling system is turned on.
Material rolls at labeling system loaded and threaded.
Labeling system is connected to power and compressed air.
System was put into operation (see chapter „Adjustment and initial
operation of labeling system").
Page 53 of 71
32708732 Geset 121