Table of Contents
Advertisement
Chapter 7 Adjustment and initial operation
Adjust peeler plate
After a product change, the position of the peeler plate to the product may be adapted.
Use for adjustment of peeler bar the position equipment of the labeler. Adjust then the
height, the distance and the angle from peeler bar to product.
Information on adjustment of peeler plate
The peeler plate has to be adjusted on a distance of approx. 1-3 mm to the product (no
product contact) by the positioning equipment of the labeler. The peeler plate should be
placed in an setting angle of 15°-30° to product.
The required label position on the product is adjusted by lateral adjustment of the labeler.
No.
1
2
3
4
Requirements
¥
Side guidance is correctly adjusted (s. page 34).
¥
Labeler is turned on and ready.
¥
One or more sample products.
¥
No transportation of products.
Version: 12.05.14
Description
PEELER PLATE
ADJUSTING SPINDLE FOR HEIGHT ADJUSTMENT
CLAMPING FOR TRAVERSE ADJUSTMENT
CRANK FOR LATERAL ADJUSTMENT
Page 36 of 56
40001684 Geset 111
Fig. 7-4: Adjust peeler plate
GB
Advertisement
Table of Contents
