System Controller User Interface - Xilinx VCK190 Series User Manual

On first use of the SCUI, select FMC → Set VADJ → Boot-up tab and click USE FMC EEPROM
Voltage. The SCUI buttons gray out during command execution and return to their original
appearance when ready to accept a new command.
See the VCK190 Software Install and VCK190 Board Setup Tutorial (XTP619) and the System
Controller Tutorial (XTP618) (which includes instructions for changing VCK190 clocks) for more
information on installing and using the system controller UI.
Switches
[Figure 3, callout 6 and 30]
The VCK190 board includes power and configuration switches:
• SW13 power on/off slide switch
• SW1 U1 ACAP PS bank 503 4-pole mode DIP switch
UG1366 (v1.0) January 7, 2021
VCK190 Board User Guide
Figure 25: System Controller User Interface
Chapter 3: Board Component Descriptions
Send Feedback
www.xilinx.com
64