Piston; Disassembly/Assembly - Honda WX15T Manual

dummyhead dummyhead
CRANKCASE

PISTON

DISASSEMBLY/ASSEMBLY

Remove the piston
MAKER MARK
SECOND RING
OIL RING
(COMBINATION RING)
PISTON PIN CLIP (2)
INSTALLATION:
Install by the setting one end of the clip in the
piston groove, holding the other end with
needle nose pliers, and rotating the clip in.
Do not align the end gap of the clip [1] with the
cutout [2] in the piston bore.
11-6
(page 11-3).
TOP RING
120°
120°
10 mm (0.4 in)
[1]
[2]
PISTON RINGS
ASSEMBLY:
Install with the maker mark facing upward as
shown.
Do not interchange the top ring and the second
ring.
After assembly, check for smooth movement of
the piston ring.
Stagger the piston ring end gaps 120° apart.
Do not align with the piston pin.
120°
10 mm (0.4 in)
CONNECTING ROD
( Big and small end bearing )
TOP RING
SECOND RING
OIL RING
(COMBINATION RING)
PISTON PIN
( Outer surface )
PISTON