Honda WX15T Manual page 73

dummyhead dummyhead
PUMP
MECHANICAL SEAL REPLACEMENT
Drive out the mechanical seal [1] from the inside using
the special tools.
TOOLS:
Driver handle [2]
Bearing driver attachment,
28 x 30 mm [3]
Drive the mechanical seal [1] until it is fully seated on
the end using the special tools.
• Be careful not to damage the sliding surface of the
mechanical seal.
TOOL:
Driver handle [2]
Oil seal driver attachment,
27.5 x 44 mm [3]
After installing, check to be sure the seal is fully seated
and is not tilted in the casing cover.
Install a new rubber ring [1] over a new ceramic ring [2].
• Be careful not to damage the sliding surface of the
ceramic ring.
Apply soapy water around the rubber ring. Install the
rubber ring/ceramic ring assembly into the impeller [3]
carefully with the rubber ring facing the impeller until it
is fully seated.
9-6
07749-0010000
07946-1870100
07749-0010000
07948-9540000
[1]
[2]
[3]
[1]
[2]
[2]
[1]
[3]
[3]