Honda WD30X Owner's Manual
  1. Manuals
  2. Brands
  3. Honda Manuals
  4. Water Pump
  5. WD30X
  6. Owner's manual

Honda WD30X Owner's Manual

Honda water pump user manual
Hide thumbs Also See for WD30X:
Table of Contents

Advertisement

Quick Links

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WD30X and is the answer not in the manual?

Questions and answers

Related Manuals for Honda WD30X

Summary of Contents for Honda WD30X

  • Page 3 This manual covers the operation and maintenance water pumps. All information duct information available at the time of printing. manual are based on the WD30X Honda Motor Co., Ltd. reserves the right to make changes without notice and without No part of this publication...

  • Page 4: Table Of Contents

    CONTENTS 1. WATER PUMP SAFETY 2. COMPONENT IDENTIFICATION -3. PRE-OPERATION CHECK ... 4. STARTING THE ENGINE ... 5. OPERATION High altitude operation 6. STOPPING THE ENGINE ... 7. MAINTENANCE 8. TRANSPORTING/STORAGE 9. TROUBLESHOOTING 10. SPECIFICATIONS 11. WARRANTY SERVICE ..

  • Page 5: Water Pump Safety

    The muffler becomes while after stopping the engine. Be careful not to touch the muffler while it is hot. Let the engine cool before storing the pump indoors. 1. WATER PUMP SAFETY or corrosive never pump sea water, or caustic...
  • Page 6 Read these labels before you operate the water pump. GASOLINE WARNING LABEL -WARNING, DO NOT PUMP FLAMMABLE OR CORROSIVE MATERIALS AN EXPLOSION OR FIRE COULD RESULT, CAUSING INJURY. SEVERE PERSONAL “V Y..” JOINT O’ETANCHEITE.

  • Page 7: Component Identification

    < WD20X > < WDBOX> THROTTLE LEV STARTER GRIP FUEL VALVE PRIMING WATER FILLER CAP SUChON ‘ORT PUMP DRAIN CAP 2. COMPONENT OIL ALERT MUFFLER FUEL FILLER PLUG IDENTIFICATION L FILLER CAP/ STRAINER...

  • Page 8: Pre-Operation Check

    3. PRE-OPERATION 1. Suction hose Use a reinforced-wall Since the pump’s self-priming short hose is recommended. Secure the hose with the hose band. CAUTION: Always pumping. Gravel or debris sucked into the pump will cause serious impeller damage. 2. Discharge hose When using a fabric hose, always use a hose band to prevent the hose from disconnecting...
  • Page 9 3. Engine Oil CAUTION: Engine oil is a major factor affecting Non-detergent and 2-stroke Be sure to check the engine on a level surface with the engine stopped. Honda 4-stroke equivalent high detergent, quality motor oil certified exceed U.S; automobile turer’s requirements Classification...

  • Page 10: Fuel Tank Capacity

    . . . 2.59 (0.66 WDZOX WD30X . . . 3.69 (0.95 that has a pump octane octane number normally display the...
  • Page 11 Gasoline is extremely tions. Refuel in a well-ventilated or allow flames or sparks where gasoline is stored. Do not overfill the fuel tank (there should be no fuel in the filler neck). After refueling, make sure the tank cap is closed properly and securely. Be careful not to spill fuel when refueling.
  • Page 12 5. Air cleaner Remove the wing nut, washer and air cleaner cover. Check the element for dirt or obstruction. Clean the element if necessary AIR CLEANER COVER AIR CLEANER ELEMENT 6. Priming water The pump chamber CAUTION: Never attempt the pump will overheat. seal.

  • Page 13: Starting The Engine

    4. STARTING THE ENGINE 1. Turn the fuel valve ON. 2. Close the choke lever. NOTE: Do not use the choke if the engine is warm or the ambient temperature is high. CHOKE LEVER FUEL VfLVE 3. Turn the engine switch to the ON position.
  • Page 14 4. Move the throttle 5. Pull the starter grip lightly until resistance CAUTION: Do not allow the starter grip to snap back against the engine. Return it gently lever slightly to the left. to prevent damage to the starter. STARTER GRIP is felt, then pull it briskly.

  • Page 15: Operation

    5. OPERATION 1. As the engine warms up, gradually open the choke. 2. Set the throttle at the desired speed. THROTTLE LEVER...

  • Page 16: High Altitude Operation

    6,000 Honda Water Pump dealer perform these car- jetting, engine horsepower will be greater than this if no carburetor of the Water Pump at an altitude...

  • Page 17: Stopping The Engine

    I, Move the throttle lever fully to the,right. 2. Turn the engine switch THROTTLE LEVER 3. Turn the fuel valve OFF. FUEL VALVE NOTE: To stop the engine in an emergency, OFF position. 6. STOPPING THE ENGINE to the OFF position. ENGINE S-WITCH turn the engine switch to the...

  • Page 18: Maintenance

    7. MAINTENANCE The purpose of the maintenance pump in the best operating condition. table below. Shut off the engine engine must be run, make sure the area is well ventilated. tains poisonous carbon monoxide CAUTION: Use only genuine replacement parts which pump.

  • Page 19: Oil Capacity

    1. Oil change Drain the oil while the engine is still warm to assure rapid and complete draining. 1. Remove the oil filler cap and the drain plug, then drain the oil. 2. Reinstall the drain plug and tighten 3. Refill with the recommended OIL CAPACITY: 0.61 (0.63 US qt) OIL FILLER CAP/...
  • Page 20 2. Air cleaner service A dirty air cleaner will restrict buretor malfunction, quently when operating Never use gasoline air cleaner element. CAUTION: Never run the pump without will result. 1. Unscrew the wing nut, remove the air cleaner cover and remove the air cleaner element.
  • Page 21 3. Spark plug service Recommended spark plug: BPRGES (NGK) To ensure proper engine operation, and free of deposits. 1. Remove the spark plug. If the engine has been running, careful not to touch the muffler. 2. Visually inspect the spark plug. Discard it if the insulator chipped.
  • Page 22 ‘4. Check that the spark plug washer is in good condition, spark plug in by hand to prevent cross-threading. 5. After the spark plug is seated, tighten with a spark plug wrench to com- press the washer. If installing a new spark plug, tighten NOTE: seats to compress the washer.
  • Page 25 4. Change the engine oil. 5. Remove the spark plug and pour about a tablespoon into the cylinder. Crank the engine several revolutions oil, then reinstall the spark plug. 6. Pull the starter rope slowly until resistance the notch on the starter pulley aligns with the hole on the recoil starter (see illustration below).

  • Page 26: Troubleshooting

    If OK, install the new plug and try to start the engine according to the instructions. 6. If the engine still does not start, take the pump to an authorized water pump dealer. the engine. Fuel vapor or spilled fuel may ignite.
  • Page 27 3. Are the hose bands installed 4. Are the hoses damaged? 5. Is the suction head too high? 6. If the pump still does not pump the water, take the pump to an authoriz- ed Honda water pump dealer. securely?

  • Page 28: Specifications

    50 mm (2 in) 3,550 32 m (105 8 m (27.9 6001 (159 US gal)/min set at 5 m (16.5 to change without WD30X’ ,520.x x 490 (20.5.x 15.7 x 19.3 30 kg (66.1 GX140 valve, 1 cylinder cc (8.8 cu in) [64 x 45 mm (2.5...

  • Page 29: Warranty Service

    Owner Satisfaction Your satisfaction and goodwill Honda warranty details are explained ty. Normally, any problems concerning dealer’s service department. been handled to your satisfaction, action: Discuss your problem with a member of dealership complaints can be quickly already been reviewed the dealership or the General Manager.
  • Page 30 When you write or call, please provide the following information: • Model and serial numbers • Name of the dealer who sold the Honda power equipment to you • Name and address of the dealer who services your equipment •...
  • Page 31 MEMO...

This manual is also suitable for:

Wd20x

Table of Contents