Table of Contents
Advertisement
3.
Secure the DX3013 to the CX1011 enclosure
wall with a mounting screw (provided with
DX3013). See Figure 32.
Mounting Screw
Enclosure Back Wall
Figure 32: Mounting the DX3013 (Step 3)
Distance from the control panel is determined by the
total combined wire length of all devices (including
keypads) connected to the control panel's Data Bus
terminals. The combined wire length must not exceed
305 m using #22 AWG (0.8 mm) wire.
19.5
DX3010 Wiring
Refer to Table 9 for Data Bus wire length
requirements.
If the DX3010 is to be installed far from the
control panel, the control panel cannot be
used to power the DX3010. An external power
supply must be used. See Figure 34 for
external power supply connections.
Power
Source
Control Panel
Control
to DX3010
Panel
Control Panel
External
to DX3010
Power
Supply
External
Power Supply
to DX3010
Table 9: DX3010 Wire Lengths
You can use either one of the Aux Power (-) terminals
and either one of the 12 VDC (+) terminals when
connecting devices to the control panel.
Page 24
P/N: 4998152533-02
PART II: SYSTEM INSTALLATION AND SETUP
Front of
Angle Bracket
Front of
DX3013
#22 AWG
#18 AWG
(0.8 mm)
(1.2 mm)
12.2 m
24.4 m
305 m
610 m
12.2 m
24.4 m
Copyright 2007 Bosch Security Systems, Inc.
DX3010
Yellow
Y
Green
G
Black (-)
B
Red (+)
R
NC
C
NO
8
Output Activated State
NC
Output De-activated State
NC
Figure 33: DX3010 to Control Panel Wiring
If you need to power the DX3010 from an external
power supply, connect it to the power supply and the
control panel.
DX3010
Yellow
Y
Green
G
Black (-)
B
Red (+)
R
NC
C
NO
8
(+)
12 VDC
External Power Supply
Figure 34: DX3010 to External Power Supply Wiring
Do not tie the black (-) output to earth
ground when using any external power
supply. A ground fault condition is reported
if black (-) is grounded.
Control Panel
Green
Yellow
Black (-)
Red (+)
BATT+
BATT-
C
NO
C
NO
Control Panel
Green
Yellow
Black (-)
BATT+
BATT-
(-)
DS7200V2-UK Installer's Guide
Hide quick links:
Advertisement
Chapters
Table of Contents
