Routing Destinations; Figure 59: Routing Destinations; Table 22: Phone Number Entry Selections - Bosch DS7200V2-UK Installer's Manual

30.0

Routing Destinations

The control panel has two routing 'destinations' for the routing of reports. The control panel routes by zone and report group to
the destinations. For example, you can send alarm reports for one zone to Destination 1 and for another zone to Destination 2.
You can program two phone numbers (or IP addresses) for each destination.
Communication Fail events are by destinations and not by phone number/IP address.
See Communication Attempt Tables on page 121 for a description of the routing/dialing process.
Phone Number 1 (2) for Destination 1 (2)
• Address Range:
− Phone Number 1, Destination 1: 0000-0031
− Phone Number 2, Destination 1: 0032-0063
− Phone Number 1, Destination 2: 0066-0097
− Phone Number 2, Destination 2: 0098-0129
• Default: All zeroes (0)
• Selections: 0-15 (see Table 22)
Digit
1
2
3
4
5
6
7
8
When entering phone numbers, use "10" ([1][0] from the keypad) to enter "0"; use "0" to terminate the
phone number. This does not apply when entering an IP address.
Terminate telephone numbers with less than 32 digits by entering a zero (0) in the address after the last
digit to be dialed.
The control panel can dial up to 32 digits per phone number. Each digit occupies one address. If less than 32 digits are
entered into the Phone Number Address range, the control panel dials digits until it reaches a terminator (0).
IP addresses can be entered into these addresses for network communication. See Network Communication on page 112 for
more information. Firmware revision 2.10 or greater is required for network communication.
See Area # Account Number on page 60 for instructions on entering an account number.
Page 42 P/N: 4998152533-02
PART IV: CONTROL PANEL PROGRAMMING
Routing Destination 1
Phone 1 Phone 2

Figure 59: Routing Destinations

Enter at the Keypad
1
2
3
4
5
6
7
8

Table 22: Phone Number Entry Selections

Copyright  2007 Bosch Security Systems, Inc.
Routing Destination 2
Phone 1
Digit
9
0
*
#
P (4-second pause)
F (on-hook, pause, off-hook)
Reserved
T (Terminate)
Phone 2
Enter at the Keypad
9
10
11
12
13
14
15
0
DS7200V2-UK Installer's Guide