Bosch DS7200V2-UK Installer's Manual page 113

Format for Destination 1 (2)
• Address:
− Format for Destination 1: 0064
− Format for Destination 2: 0130
• Default: 2 (Contact ID)
• Selections:
− 2 = Contact ID
− 3 = SIA 300
− 4 = Basic Pager
− 6 = BSIA Fast Format
− 7 = Personal Dialing Format
− 11 = SIA 300 with Text Blocks
If you enable network communication, the control panel automatically selects Contact ID as the reporting format. Contact ID
only supports four-digit account numbers. As a result, the control panel automatically truncates account numbers to four digits.
Alternate Communication Options
• Address Range:
− IP Address 1, Destination 1: 3506
− IP Address 2, Destination 1: 3514
− IP Address 1, Destination 2: 3522
− IP Address 2, Destination 2: 3530
• Default: 0
• Selections: 0, 1, 3, 5, 7
Alternate Communication Options
No Alternate Communication
Enable Alternate Communication
Enable Anti-Replay
Use ARC Acks
Reserved
• Enable Alternate Communication: Select this option to enable network communication. You must enter at least one IP
address as a routing destination. See IP Address 1 (2) for Destination 1 (2) on page 112 for more information.
• Enable Anti-Replay: Anti-replay prevents unauthorized messages from being sent to the ARC and being recognized as
having originated from the control panel. Enable this option to use the anti-replay procedure. To use this option, make sure
"Include IP Address" is enabled in Network Interface Module Options on page 115.
• Use ARC Acks: If this option is enabled, the control panel waits for an acknowledgment (Ack) from the ARC before sending
a second message. If this option is disabled, the control panel waits approximately 120 seconds between sending messages
(disable only for special applications).
Remote Programming Callback Number Alternate Communication Options
• Address: 3538
• Default: 0
• Selections:
− 0 = No Alternate Communication
− 1 = Enabled Alternate Communication
If an IP address is entered into the Remote Programming Callback Number addresses (Addresses 0181-0212), RPS can be
used to program the control panel over an Ethernet network.
Select "1" if an IP address is entered in the Remote Programming Callback Number addresses.
DS7200V2-UK Installer's Guide
0 1
•
•
Copyright  2007 Bosch Security Systems, Inc.
Enter This Data Digit to Select Options
2 3 4 5 6 7 8 9 10 11 12 13 14 15
• • •
• •
• •
PART IV: CONTROL PANEL PROGRAMMING
P/N: 4998152533-02 Page 113