Table of Contents
Advertisement
3.7 Maintenance Programming Level
To access Maintenance Programming mode, press the Enter key. The LCD will display
the following:
1=READ@STATUS
2=PROGRAMMING
To enter the Maintenance Programming mode, press 2. The display will read as follows:
PROGRAMMING
ENTER@PASSWORD
When the Maintenance level password (default 11111) is entered, the following screen
will appear:
@@@@PROGRAMMING
1=POINT@PROGRAM
2=HISTORY
3=PROGRAM@CHECK
Note that in the preceding screens, an arrow appears to inform the programmer that
additional options can be viewed by pressing the keypad down arrow key, as shown in the
following screen.
@@@@PROGRAMMING
1=WALKTEST
2=SYSTEM
3=ZONE@SETUP
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Unimode 9600 and is the answer not in the manual?
Questions and answers