Accessories; 1: Pk-9600 Programming Utility; 2: Dress Panel; 3: Battery Box - ADT Unimode 9600 Installation And Operating Instruction

Accessories

1.8 Accessories
Unimode 9600 PN 51336:C 11/06/01
1.8.1 PK-9600 Programming Utility
The PK-9600 Programming Utility can be used to program an Unimode 9600 directly
from most IBM compatible computers, including laptops and portables, equipped with a
serial port. Unimode 9600 program files can also be created and stored on the PC and then
downloaded to the control panel. The PK-9600 Kit includes the Windows-based
Programming Utility software on CD-ROM with on-line help file. A serial cable (P/N:
PRT/PK-CABLE), which must be purchased separately, is required for connection of the
PC to the RS-232 (PC/Printer) terminals at TB7 of the Unimode 9600 main circuit board.
Refer to the illustration on page 10 and the section titled "Printer/PC" on page 34, for the
location and connections to this terminal.
1.8.2 Dress Panel
A dress panel is provided standard with the Unimode 9600 (required for Canadian
installations). The dress panel restricts access to the system wiring while allowing access
to the key panel.
Note that the Unimode 9600 FACP, installed with the dress panel, has received Factory
Mutual (FM) approval. FM approval is contingent on the proper installation of the dress
panel.
1.8.3 Battery Box
BB-17F
The BB-17F battery box may be used to house up to two 18 AH batteries in the event that
room is not available in the main cabinet due to the use of a ADT-UDACT, 411UD, etc.
The battery box mounts directly below the FACP cabinet. The battery box is red and is
provided with knockouts.
CAUTION: HIGH VOLTAGE UNDER PANEL
!! WARNING !!
SEVERAL DIFFERENT SOURCES OF POWER
CAN BE CONNECTED TO THIS CONTROL UNIT
DISCONNECT ALL SOURCES OF POWER BEFORE SERVICING
Product Description
21