Master Programming Level - ADT Unimode 9600 Installation And Operating Instruction

3.6 Master Programming Level

When the Master Program Level password is entered, the control panel will enter user
Programming mode. In this mode, the piezo sounder remains off, the trouble relay is
activated and the system Trouble LED flashes until Programming mode is exited. The
following display will appear:
@@@@PROGRAMMING
1=POINT@PROGRAM
2=ZONE@SETUP
3=LOOP@SETUP
The down arrow which appears in the display indicates that additional programming
choices can be viewed by pressing the down arrow key on the keypad. If a down and up
arrow appear in the display, pressing the 'down' arrow key will display the subsequent
Programming Screens as illustrated below while pressing the 'up' arrow key will display
the previous screen.
@@@@PROGRAMMING
1=SYSTEM@SETUP
2=AUTOPROGRAM
3=VERIFY@LOOPS
@@@@PROGRAMMING
1=HISTORY
2=WALKTEST
3=OPTION@MODULES
@@@@PROGRAMMING
1=PASSWORD@CHANGE
2=CLEAR@PROGRAM
3=PROGRAM@CHECK
Programming Screen #1
Programming Screen #2
Programming Screen #3
Programming Screen #4