DURKOPP ADLER 610-10 Operating Instructions Manual page 59

Settings via software
Mode AUTO Setting the sewing material size
Operating Instructions 610-10/630-10 - 01.0 - 01/2021
2. Tap the OK button.
 The selected sewing program is loaded in AUTO operating
mode.
You can tap the Abort button to cancel the selection of the
program.
 The user interface for AUTO operating mode is displayed.
Abb. 30: Setting the sewing material size
The following information is displayed:
• Divided into up to 4 segments, each size table illustrates
the corresponding size groups. The currently selected size
is indicated by a double arrow (>>).
• The sizes marked in red indicate the sizes in which the
sewing program was created or modified.
To set the sewing material size:
1. Select the size table.
2. Tap the desired sewing material size.
 The user interface for AUTO operating mode is displayed.
57