DURKOPP ADLER 610-10 Operating Instructions Manual page 118

Code Type
1000 Error
1001 Error
1002 Error
1004 Error
1005 Error
1006 Error
1007 Error
116
Table of software messages
Possible causes
Sewing motor error:
• Encoder plug
(Sub-D, 9-pin) not connected
or defective
• Encoder defective
Sewing motor error:
• Sewing motor plug not
connected or defective
Sewing motor insulation error
Sewing motor error:
• Incorrect direction of rotation
Sewing motor current error:
• Sewing motor blocked
• Encoder cable not
connected or defective
• Encoder defective
Sewing motor error:
• Max. speed exceeded
• Sewing motor cable defective
• Sewing motor defective
Error in the reference run
Operating Instructions 610-10/630-10 - 01.0 - 01/2021
Troubleshooting
Remedial action
• Check the connection of the
encoder cable and replace, if
necessary
• Check the connection of the
sewing motor cable
• Test sewing motor phases
(R = 2.8Ω, high impedance to
PE)
• Replace the encoder
• Replace the sewing motor
• Replace the controller
• Check motor phase and PE for
low-impedance connection
• Replace the encoder
• Replace the sewing motor
• Replace the encoder
• Check plug assignment and
change, if necessary
• Check wiring in machine distribu-
tor and change it, if necessary
• Test motor phases and check for
correct value
• Remove the blockage
• Check the encoder cable and
replace, if necessary
• Replace the sewing motor
• Switch the machine off and
on again
• Replace the encoder
• Perform reset
• Replace the sewing motor
• Contact customer service
• Replace the encoder
• Eliminate stiff movement in the
machine