DURKOPP ADLER 610-10 Operating Instructions Manual page 131

Troubleshooting
Code Type
2480 Error
2481 Error
2482 Error
2483 Error
2484 Error
2485 Error
2486 Error
2487 Error
2488 Error
2901 Error
3010 Error
Operating Instructions 610-10/630-10 - 01.0 - 01/2021
Possible causes
Direction of rotation
Error in the reference run
Stepper motor current error
Stepper motor overcurrent
Software error
Stepper motor insulation error
Software error
Software error
Software error
Referencing timeout
Controller: 100 V voltage error
Remedial action
• Replace the encoder
• Check plug assignment and
change, if necessary
• Check wiring in machine distribu-
tor and change it, if necessary
• Test stepper motor phases and
check for correct value
• Replace the reference switch
• Remove the blockage
• Check the encoder cable and
replace, if necessary
• Replace the stepper motor
• Replace the sewing motor cable
• Replace the stepper motor
• Replace the controller
• Perform reset
• Performing a software update
• Contact Customer Service
• Check motor phase and PE for
low-impedance connection
• Replace the encoder
• Replace the stepper motor
• Perform reset
• Performing a software update
• Contact Customer Service
• Perform reset
• Performing a software update
• Contact Customer Service
• Perform reset
• Performing a software update
• Contact Customer Service
• Switch the machine off and on
again
• Check the clamping of the
stepper motor
• Check the connections
• Replace the controller
129