Table of Contents
Advertisement
This area is for editing or resetting the service reminders
once a service has been completed and is different than
the SERVICE REMINDERS in the MAIN MENU where
users can check on the status of the service reminders
to see how many hours until the next service is required.
Scroll up or down through this screen using « or » buttons.
The
button returns to the previous menu.
Press the "Edit" button to access the Service Remain-
ders editing screen. Use the reset button to get back to
factory settings.
Figure 4.28 – Edit Service Reminders
PG Control
This sub-menu is used by developers or trained personnel
only and is beyond the scope of this Operator Manual.
Figure 4.29 – PG Control Screen
Back-Up Camera Setup
This sub-menu is used by developers or trained personnel
only to setup an optional back-up camera.
Clear Faults
As the title implies, this sub-menu is used to clear any
engine or system faults and it is used by developers or
trained personnel only.
XR5919-A
The LMI Display
The main features of the menu-driven LMI display are:
1 Function Keys F1 -F4 – displayed on TFT
2 Digital TFT Color Display
3 Function Keys F5 -F8 – displayed on TFT
4 LED Status Indicators
5 Rotary Control Knob – with push button function
6 Home Key – for return to main menu
7 USB Port – for service use
8 Set Key – confirm and accept the chosen settings
9 Escape Key – abort and return to previous screen
Figure 4.30 – LMI Display
Start Up
The LMI system display does not have a power button.
It powers up whenever the ignition key is turned ON and
it needs to be fully booted before operating the forklift.
When the system boots up, one of two screens will ap-
pear. If the unit has been off for more than 3 hours, the
Standard configuration screen will be displayed.
Figure 4.31 – Configure Operation Mode
If the system was on within the last 3 hours, the CONFIRM
OP-MODE screen will appear.
Chapter 4 – Controls
23
Advertisement
Table of Contents
